EasyManua.ls Logo

Miele PG 8060 - Warning and Safety Instructions

Miele PG 8060
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Warning and Safety instructions
9
Correct installation
Do not install this dishwasher in an area where there is a risk of
explosion or freezing conditions.
To ensure stability a built-under dishwasher must only be installed
beneath a continuous worktop that is bolted to the adjacent
cabinetry.
In order to reduce the risk of damage from condensation, the
furniture in the area around the dishwasher should ideally be
designed for commercial use.
Furniture can be protected using the vapour protection set, which is
available as an optional accessory.
The vapour barrier film should be stuck under the worktop in the area
around the dishwasher door.
Technical safety
This dishwasher must only be commissioned, repaired and
maintained by the Miele Customer Service Department, a dealer or a
suitably qualified service technician. Unauthorised installation,
maintenance and repairs can cause considerable danger for the user.
This dishwasher must only be operated by appropriately trained
personnel. They must be instructed and trained regularly.
Before using the dishwasher, check it for any externally visible
damage. Do not use a damaged dishwasher. This could be
dangerous.
In the event of a damaged or leaking dishwasher, switch off at the
power supply immediately and call the Miele Customer Service
Department, a Miele dealer or a suitably qualified service technician.
Faulty components must only be replaced by genuine Miele
original spare parts. Only when these parts are fitted can Miele
guarantee the correct functioning and safety of the appliance.
The electrical safety of this dishwasher can only be guaranteed
when correctly earthed. If in any doubt, please have the electrical
installation tested by a qualified electrician.
Please follow the advice on installation in these operating
instructions and the installation plan.
Before connecting the appliance, ensure that the connection data
on the data plate (voltage, frequency and fuse rating) match the
mains electrical supply.
There must be no electrical sockets behind the dishwasher. Danger
of overheating and fire risk if the dishwasher were to be pushed up
against a plug. See “Electrical connection”.

Table of Contents

Related product manuals