Installation
*INSTALLATION*
115
Floor anchoring
The dishwasher must be prevented from tilting or moving by
anchoring both rear machine feet to the floor.
Fix the floor anchoring to the floor at the same distance as the two
rear machine feet using the anchoring kit supplied.
If necessary, adapt the anchoring to the respective ground
conditions on site.
Slide the dishwasher into the designated holder of the floor
anchoring.
Moving the dishwasher
Before moving the dishwasher screw in the adjusting feet fully so that
they do not get damaged.
Do not lift the dishwasher by any protruding components, e.g.
the control panel.
This could break off.
Only transport the dishwasher on a sack barrow in its original
packaging. For subsequent moves the dishwasher must be placed
on a continuous base to avoid damage.
To Next Page
Loading...
