Drying unit maintenance
How to change the coarse filter
If
Change coarse filter appears in the
display, the coarse filter needs to be
replaced.
^
Pull open the control cabinet drawer.
^ Remove the filter mesh at the front of
the drying unit.
^
Change the coarse filter. The soft
side of the filter must face the front.
^ Re-insert the filter mesh at the
bottom, then press it into place at the
top.
^ Close the control cabinet drawer.
After changing the coarse filter, you
must reset the operating hours counter.
To do this:
^
Select
CHANGE COARSE TA and
start the program by pressing the h
button.
When the service program has finished,
the display will show a message.
^
Confirm this message with OK.
The system displays the program
overview.
Maintenance of the washer-disinfector
64
To Next Page
Loading...
