Before using for the first time
18
Running the first programme
For safety reasons, spinning is not pos-
sible until the machine has been pre-
pared for use for the first time. To activ-
ate the spinning function, you must run
a wash programme without laundry and
without detergent.
Using detergent could result in an ex-
cessive build-up of foam!
Open the stopcock.
Turn the programme selector to the
Cottons position.
The washing machine is now switched
on and the temperature 60°C lights up
in the control field.
Touch the Start/Stop sensor control.
The programme starts and the sym-
bol lights up in the control field.
After 10minutes, the indicators dim
and the Start/Stopsensor control
starts flashing.
At the end of the programme, the Anti-
crease function is switched on. The
symbol lights up in the control field;
: appears on the time display.
Touch the Start/Stop sensor control.
The door will unlock.
Reach under the door grip and pull
the door open.
Tip: Leave the door slightly open to al-
low the drum to dry.
When the programme has ended,
turn the programme selector to.
The washing machine is switched off
and is now ready for use.
To Next Page
Loading...
