Cleaning and care
36
Cleaning the detergent drawer
Use a bottle brush to remove deter-
gent residues and limescale from the
jets inside the detergent drawer.
Replace the detergent drawer.
Tip: Leave the detergent drawer slightly
open to allow it to dry.
Cleaning the casing and fascia
panel
Damage caused by detergents.
Solvent-based cleaning agents, ab-
rasive cleaners, glass cleaners or
multi-purpose cleaning agents can
cause damage to plastic surfaces
and other parts.
Do not use any of these cleaning
agents.
Risk of damage due to ingress of
water.
The pressure of a water jet can
cause water to get into the washing
machine, resulting in damage to
components.
Do not spray the washing machine
with a water jet.
Clean the casing and fascia panel
with a mild cleaning agent or soap
and water and dry both with a soft
cloth.
The drum and any other stainless
steel components can be cleaned us-
ing a suitable stainless-steel cleaning
agent.
Cleaning the drum, suds con-
tainer and drainage system
The drum, suds container and drainage
system must be cleaned whenever the
indicator light comes up or if neces-
sary.
Start the Cottons 90°C programme
without a load.
Add powder detergent to the
compartment in the detergent
drawer.
At the end of the programme, check
the inner drum and remove any
coarse residues.
To Next Page
Loading...
