Miele PWM 300 SmartBiz - Starting the programme - end of the programme; Programme start, mid-cycle addition, and completion

5. Starting the programme – end of the programme
27
Starting the programme
 Touch the flashing Start/Stop sensor
control.
The door will lock and the programme
will start.
– As long as the symbol is flashing
in the control field, you can add laun-
dry.
– When the symbol lights up con-
stantly, the door is locked until the
end of the programme.
If a Delay start time has been selected,
this counts down on the time display. At
the end of the Delay start time or imme-
diately after the programme has started,
the programme duration appears on the
time display.
Energy savings
After 10minutes, the indicators dim.
The Start/Stop sensor control flashes
slowly.
To reactivate the indicators:
 Touch the Start/Stop sensor control
(this does not have any effect on a
programme that is running).
End of programme
The time display shows0:00. The
symbol will remain lit up in the con-
trol field. The door is locked in the anti-
crease phase.
 Touch the Start/Stop sensor control.
The door unlocks and the symbol in
the control field goes out.
 Pull open the door.
 Remove the laundry.
Items left in the drum could discolour
other items in the next wash or be-
come discoloured themselves.
Remove all items from the drum.
 Check the door seal for any foreign
objects.
Tip: Leave the door slightly open to al-
low the drum to dry.
 Turn the programme selector to the
position. This switches the wash-
ing machine off.
 If applicable, remove the used cap-
sule from the detergent drawer.
Tip: Leave the detergent drawer slightly
open to allow it to dry.