Miele PWM 300 SmartBiz - Programmable functions; Selecting and accessing programmable functions

Programmable functions
63
The programmable functions are used
to alter the machine’s electronics to
suit changing requirements. Program-
mable functions can be altered at any
time.
Programming is carried out in 9 steps
(, , ... ) using the sensor con-
trols.
Opening the programming level
Prerequisites:
– The washing machine is switched on
and the programme selector is point-
ing to a wash programme.
– The washing machine door is open.
 Touch the Start/Stopsensor control
and hold it down whilst carrying out
steps –.
 Close the washing machine door.
 Wait until the Start/Stopsensor con-
trol lights up constantly
...
 ...and then release the Start/
Stopsensor control.
After a few seconds,will light up on
the time display.
Choosing and selecting a pro-
grammable function
The number of the programmable
function will appear on the time dis-
play as and a number, e.g..
 Touch the or sensor control to
scroll to the next or previous pro-
grammable function:
Programmable functions
 End of programme tone
 Sensor control tone
 PIN code
 Control field switch-off status
 Memory
 Additional pre-wash time
 Temperature reduction
 Maximum rinse level
 Suds cooling
 Anti-crease
 Low water pressure
 Backlight brightness dimmed
 Welcome tone
 Confirm the selected programmable
function by touching theStart/
Stopsensor control.