Miele PWM 300 SmartBiz - Error messages, symbols, and fault indicators

Problem solving guide
39
Programme cancellation and error message
Problem Cause and remedy
The fault indicator
light lights up,
and appear altern-
ately on the time display
and the buzzer sounds.
The water inlet is blocked or restricted.
 Check whether the stopcock has been properly
opened.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The fault indicator
light lights up,
and appear alternately
on the time display and
the buzzer sounds.
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum drain height is 1m.
and appear altern-
ately on the time display
and the buzzer sounds.
There is a fault.
 Disconnect the washing machine from the mains
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by dis-
connecting it at the circuit breaker.
 Wait at least 2minutes before reconnecting the
washing machine to the electricity supply.
 Switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact the
Customer Service Department.
The fault indicator
light lights up,
and appear altern-
ately on the time display
and the buzzer sounds.
The water protection system has reacted.
 Close the stopcock.
 Call the Miele Customer Service Department.