Miele PWM 507 - A fault message appears in the display

Problem solving guide
55
A fault message appears in the display
1)
Problem Cause and remedy
 Container empty
One of the external detergent containers is empty.
 Refill the detergent container.
 Container 1 empty
External detergent container 1 is almost empty.
The message can refer to containers 1 to 6.
 Refill the detergent container.
 Reset the container's early-warning counter (see
“Early-warning counter” under “Supervisor level”)
 Hygiene info: run the
Maintenance hy-
giene programme, or
a programme of at
least 60°C
During the last wash, a wash programme with a tem-
perature below 60°C or the Drain/Spinprogramme
was selected.
 Start a programme with a minimum temperature of
60°C or the Maintenance wash hygienepro-
gramme.
 Check hot water in-
let
The hot water supply is blocked or restricted.
 Check whether the hot water stopcock has been
properly opened.
 Check whether the inlet hose is kinked.
 Align machine. Laun-
dry not properly spun
The selected spin speed was not reached during the
final spin due to excessive imbalance.
 Check that the washing machine is level.
 Start the spin cycle again.
 Machine is leaking
The washing machine or drain valve is leaking.
 Close the stopcock.
 Call Miele Service.
1
The messages will appear at the end of the programme and when the washing
machine is switched on and must be acknowledged with the OK sensor control.