Miele PWM 507 User Manual

Installation
72
Water connection
Cold water connection
The washing machine should be con-
nected to a mains water supply in ac-
cordance with current local and national
safety regulations. The German author-
ities do not require it to have a non-re-
turn valve as the washing machine has
been designed to comply with DIN reg-
ulations.
In the U.K. both the hot and cold wa-
ter supplies must be connected to
the mains water connection with the
provided double check valve. Hot
water temperature must not exceed
60 °C.
The flow pressure must amount to a
minimum of 100kPa and must not ex-
ceed 1000kPa. If the pressure exceeds
1000kPa, a pressure reducing valve
must be installed.
For the connection, a stopcock with a
¾" screw thread is required. If this type
of stopcock is not available, only a
qualified installer may connect the
washing machine to the mains water
supply.
The connection point is subject to
mains water pressure.
Turn on the stopcock slowly and
check for leaks. Correct the position
of the washer and screw thread if ap-
propriate.
The inlet hose for cold water is not
suitable for connection to a hot water
supply.
Switching to cold water operation
If the washing machine is not connec-
ted to a hot water point, you will have to
configure the settings Main wash water,
Pre-wash water and Rinse water to cold
(see “Supervisor level”).
 Unscrew the hot water hose.
 Screw on the stopper provided.
Maintenance
Only use genuine Miele hoses that have
been tested to withstand pressure of at
least 7000kPa should you ever need a
replacement.
A filter is located in the open end of
the inlet hose and another in the in-
take point to protect the water inlet
valve.
Neither filter may be removed.
Hose extension
Longer hoses of 2.5m or 4.0m in
length are available from Miele or from
your Miele dealer as accessories.

Miele PWM 507 Specifications

General

Drum capacity	7 kg
Delay start (max)	24 h
Spin-drying class	A
Maximum spin speed	1600 RPM
Noise level (spin)	72 dB
Noise level (wash)	- dB
Delayed start timer	Yes
Number of washing programs	-
Current	16 A
AC input voltage	400 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	37 L
Energy consumption washing per cycle	- kWh
Door hinge	Right
Water fill	Cold, Hot
Drum volume	64 L
Control type	Rotary
Loading type	Front-load
Product color	White
Door opening angle	167 °
Appliance placement	Freestanding
Package weight	104000 g

Weight and Dimensions

Depth	714 mm
Width	605 mm
Height	850 mm
Weight	100000 g
Door diameter	300 mm