Miele PWM 507 - Low water pressure

Supervisor level
82
Low water pressure
If the water pressure is below 100kPa
(1bar), the programme will be can-
celled and the fault message Check
water inlet will appear.
If the on-site water pressure cannot be
increased, activating the setting Low wa-
ter pressurewill prevent the programme
from being cancelled.
Factory default: Off
Empty sensor
A siphon contact can be used to de-
tect whether external detergent con-
tainers are empty. A message appears
if a container is empty.
– Off (factory default)
The Empty sensing function is
switched off.
– Normally open contact
The siphons are equipped with a nor-
mally open contact.
– Normally closed contact
The siphons are equipped with a nor-
mally closed contact.
Early warning counter
An internal counter reports when an
external dispenser container is almost
empty. The counter in question then
has to be reset.
Water level Cottons
You can increase the water level for
the main wash in the Cottonspro-
gramme.
– + 0mm wc (factory default)
– + 10mm wc
– + 20mm wc
– + 30mm wc
Water level Minimum iron
You can increase the water level for
the main wash in the Minimum
ironprogramme.
– + 0mm wc (factory default)
– + 10mm wc
– + 20mm wc
– + 30mm wc
Cottons Pre-wash temp
You can select the temperature for the
pre-wash in the Cottonsprogramme.
– 30°C (factory default)
– 35°C
– 40°C
– 45°C