Miele PWM 507 - Delay start

Supervisor level
80
Anti-crease
The Anti-crease function reduces
creasing after the end of the pro-
gramme.
At the end of the programme, the drum
continues to turn at intervals for up to
30minutes. The washing machine door
can be opened at any time.
Factory default: On
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a pro-
gramme with a temperature of 70°C or
higher is selected.
Suds cooling should be activated:
– To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– Where the drainage pipes do not
comply with DIN1986.
Factory default: On
Delay start
The type of time input for the Delay
start function can be changed or
switched off.
– Off
The Delay start function is not avail-
able for selection.
– End of programme (factory default)
With the Delay start function, you
specify at what time the wash pro-
gramme should end.
– Beginning of programme
With the Delay start function, you
specify at what time the wash pro-
gramme should begin.
– Time until start
With the Delay start function, you
specify after how many hours a pro-
gramme should begin (up to 96h).
Programme name
When selecting a standard pro-
gramme, the name of the selected
programme is shown in the display.
– On (factory default)
When a programme is selected, the
programme name is displayed for a
few seconds before the display
shows the main menu.
– Off
The main menu is displayed immedi-
ately.