Miele PWM 507 - Page 58

Problem solving guide
58
Problem Cause and remedy
There is still liquid in the
capsule at the end of
the programme.
There is a blockage in the small pipe in the detergent
drawer onto which the capsule is placed.
 Clean the small pipe.
Not a fault. For technical reasons, a small amount of
water will remain in the capsule.
There is water next to
the capsule in the fabric
conditioner compart-
ment.
The CapDosing sensor control was not activated or an
empty capsule was not removed at the end of the last
wash programme.
 Activate the CapDosing sensor control when a cap-
sule is next used.
 Remove and dispose of the empty capsule at the
end of each programme.
There is a blockage in the small pipe in the detergent
drawer onto which the capsule is placed.
 Clean the small pipe.