Technical Information
W1900 Series Clothes Washers
6.3 Fault Codes
Applies Only to Models W1966 & W1986
Retrieval
1. Access the Service Mode – Refer to Section 6.2.
2. Turn the Program Selector Switch to the WOOLENS 85 position.
3. Use table 6-3 to determine the stored fault
On the W1966 note the status of the LED Indicators
On the W1986 the fault is displayed in the “Time Remaining”
Display Window (Example: F1)
W1966 LED Status
W1986
Display
Fault
- Cor No Faults Stored
Pre-Wash LED Flashes Faster F1 Pressure Sensor Fault
Main Wash LED Flashes F2 NTC Sensor Fault
Rinse LED Flashes F3 Heating Fault
Rinse/Hold LED Flashes F4 Tachogenerator Fault
Oversuds LED is on F5 Oversuds Condition Logged
Water Intake LED is on F6 Water Intake Fault
Check Darin LED Flashes F7 Water Drainage Fault
(to be updated) F8 No Final Spin
(to be updated) F9 NV RAM Fault
Table 6-3: Fault Codes (W1966 & W1986)
Clearing a Stored Fault Codes
1. Access the Service Mode
2. Place the Program Selector Switch to the WOOLENS 85 position
(Fault Code Retrieval position).
3. While a fault is displayed – Switch off the appliance.
51
To Next Page
Loading...
