Technical Information
W1900 Series Clothes Washers
Additional Fault Indicators – W1966 & W1986 only
“Door Lock”
LED flashes
The lock function has been activated. Deactivate
the lock function to clear.
“Check Drain”
LED flashes
Buzzer sounds and “- - -“
appears in the display.
(W1986 only)
Water Drainage Failure
“Water Intake”
LED flashes
Buzzer sounds and “- - -“
appears in the display.
(W1986 only)
Water Intake Failure
“Pre-Wash” OR “Rinse”
LED Flashes
Buzzer sounds and “- - -“
appears in the display.
(W1986 only)
Check for stored faults in the Service Mode.
“Oversudsing”
LED is ON
An oversudsing condition is present.
1. Run a drain cycle.
2. Ensure the correct type and/or amount of
detergent is being used.
“Anti-Crease”
LED flashes
The Program Selector Knob has been moved after
a program was started.
Turn the Selector Knob back to the originally
selected program position to clear.
Table 6-10: Fault Indicators (Continued from Table 6-9)
66
To Next Page
Loading...
