Technical Information
W1900 Series Clothes Washers
F6: Insufficient Water Intake
x Check water supply is fully opened.
x Clean the Water Intake Filters.
x Check supply water pressure.
x Check Intake Valves - as necessary.
x Check / adjust the appliance programming.
F7: Insufficient Drainage
x Check filter for blockages.
x Check Drain Hose.
x Check Drain supply (at install location) for proper draining.
x Check Drain Pump (mechanical / electrical).
x Check Non-Return Valve.
F8: Spin Speed Not Maintained
During the last 2 seconds of the final spin, the spin speed must be > 400
rpm. If this is not the case, the fault code F8 is then stored.
x Minimize imbalances by opening the door & redistributing the laundry
by hand. Repeat the spin.
Note:
With small load quantities, it may be necessary to add additional items as
ballast.
F9: NV RAM (non-volatile RAM) Fault
x Perform the "Determining Which Electronic Unit Requires
Replacement (Electronic Test Procedure)" – Refer to Section 5.13.
53
To Next Page
Loading...
