OM-248965 Page 32
C. Carbon Arc Cutting (CAC)
Allows carbon arc cutting to be
enabled or disabled.
. CAC can be loaded on any of the
eight programs by selecting the
process using the Process Set up
button.
After entering the user interface
menu, the initial display will vary by
the first item that appears.
Upper display push button LED
flashes to indicate this menu item
is available for selection. Press
the upper display push button.
SW
REV
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
CAC
ENBL
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
ENBL
CAC
Rotate Adjust knob until Carbon
Arc Cutting Enable (CAC ENBL)
appears on the display.
Rotate Adjust knob to select NO
or YES.
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
ENBL
NO
LED
Unit goes back to it standby status.
ENBL
YES
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
The Set Up push button LED flashes
indicating that pressing this button will
enable carbon arc cutting. Press the
Set Up push button.
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
25
200
ENBL
YES
Trigger Control
Program
Process
Wire Type
Gas Type
Process Set up
Volts Time Arc Adjust
WFS Amps Arc Ctl
Sequence
Trigger Hold
Adjust Feeder Set Up
To exit the user interface menu, momentarily
press the Program push button and lower
display push button at the same time.
To Next Page
Loading...
Need help?
General
