12. Change the algebraic sign and numerical
value of the lower warning limit as required
(see section “Changing numerical values for
parameter settings” in Chapter 0).
13. Once the algebraic sign and numerical value
have been set as required, press the START
key. This terminates the process and the set
value flashes.
14. Press the START key again to adopt the
flashing value as the current setting. The dis-
play then returns to the catalog of functions
and parameters item “WARN. – (1.4.5)”.
If at this point either the MASTER or DATA
key is pressed instead of START, the display
returns to the numerical value setting stage
(cf. point 11). The indicated numerical value
can be changed again.
15. If no further settings are to be made in the
catalog of functions and parameters, press
the START key. The standard display ele-
ments appear.
If further settings are necessary, navigate
to the appropriate point of the catalog of
functions and parameters using the ESC,
MASTER, DATA and MENU keys and carry
out the settings as required.
In contrast to the tolerance lim-
its, the warning limits are not
entered on the scale. The warn-
ing limits are monitored using
the status lamps. The colors of
the status lamps change when
the entered numerical values
are reached.
To Next Page
Loading...
Need help?
General
