14. Press START again to adopt the flashing
measurement period. The display then re-
turns to the catalog of functions and param-
eters item “TIMER (3.1.2)”.
If at this point either the MASTER or DATA
key is pressed instead of START, the display
returns to the numerical input stage (cf. point
12). An alternative measurement period can
be selected.
15. Press the MASTER key. “CYCLE (3.1.3)” is
displayed.
16. Press the MENU key. “T-PAUSE” and the
numerical value, the first digit of which flash-
es, appear.
17. Enter the duration of the pause period in
seconds as required (see section “Changing
numerical values for parameter settings” in
Chapter 0).
18. Press START once the pause period has
been entered. This terminates the process
and the set pause period flashes.
19. Press START again to adopt the flashing
pause period. The display then returns to the
catalog of functions and parameters item
“CYCLE (3.1.3)”.
If at this point either the MASTER or DATA
key is pressed instead of START, the display
returns to the numerical input stage (cf. point
17). An alternative pause period can be en-
tered.
20. If no further settings are to be made in the
catalog of functions and parameters, press
the START key. The standard display ele-
ments appear.
Once the standard display ele-
ments appear, a measurement
or measuring series can be initi-
ated by pressing START. If the
operating mode “AUTOM.” has
been selected, “MEASURE” is
displayed during measurement
and “PAUSE” during the pause
between measurements. If the
measuring series is terminated
by pressing START, “ABORT”
appears briefly on the display.
Please also read the notes in
the following chapters relat-
ing to the operating modes
“NORMAL” and “AUTOM.”.
If further settings are necessary, navigate
to the appropriate point of the catalog of
functions and parameters using the ESC,
MASTER, DATA and MENU keys and carry
out the settings as required.
To Next Page
Loading...
