9. Use the DATA and MASTER keys to select
the desired setting. The following settings
are available:
DAC OFF No features are output via the
analog output.
LINE 1 The feature indicated on the top
line of the numerical measured
value display will be output.
This, however, is only possible if
two features are indicated at the
same time (see Chapter 3.5)!
LINE 2 The feature indicated on the bot-
tom line of the numerical mea-
sured value display will be out-
put.
ANALOG The feature indicated on the
analog scale will be output. The
output voltage depends on the
deflection of the pointer on the
scale.
10. Press START once the desired setting is indi-
cated. The setting is adopted and „FEATR.
(4.7.3.1)“ is displayed again.
11. If no further settings are to be made in the
catalog of functions and parameters, press
the START key. The standard display ele-
ments appear.
If further settings are necessary, navigate
to the appropriate point of the catalog of
functions and parameters using the ESC,
MASTER, DATA and MENU keys and carry
out the settings as required.
To Next Page
Loading...
Need help?
General
