Internal Checks
•
If the integral ST-H temperature sensor is not used, jumper ‘J2’ must be
set to ‘TS/P65’.
•
Make sure that voltage stab connector, ‘J9’, is properly set for either 100,
115, 200 or 230 V AC operation.
•
One fuse, 1/4 Amp, must be installed.
•
Make power connection. Be sure that wires are securely fastened and to
proper terminals,
do not operate with grounding (earthing) wire disconnected.
■
PL-399 3 – 3
To Next Page
Loading...
