MIMAKI fine Cut 3 - Page 18

16
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
2 Click Add button to add a media on the Edit Media/Tool
dialog.
Click OK button to add the media to the list.
Double-click on the target condition to change the setting.
Alternatively, click Edit button.
3 Click Set button to save the cut condition.
In case any setting value exceeds the limit value on the plotter, plotting is
performed based on the limit value of the plotter. For the limit values, refer to
the Operation Manual.