MIMAKI fine Cut 3 - Set Head Position and Origin Automatically after Plot

17
○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Set Head Position and Origin Automatically after Plot
When checking [Head Withdrawal After Plot] check box, the plotter head move to the
specified position after plotting the data. When clicking Set button, enable to set up
the withdrawal position and Origin Update.
(On the default condition, the withdrawal position is set to the Max.plot length +1 cm
without [Sheet Feed Origin Renewal].)
Click Set button to change the head withdrawal position or set the origin to the with-
drawal position.
[Head Withdrawal Position] dialog appears.
(1)Set the head withdrawal position for the horizontal direction.
Reference position from either [Current Origin] or [Max Plot Length].
For example, the head is withdrawn to the position at 0 mm from Current Origin for
the horizontal direction in the figure above.
(1)
(2)
(3)