MIMAKI fine Cut 3 - Recognize and cut Registration Mark (in use of CG-EX series)

23
○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Recognize and cut Registration Mark (in use of CG-EX series)
1 Set the output result on a plotter to perform registration
mark detection.
For the procedure of registration mark detection, refer to the Mimaki CG-EX series
operation manual.
Detection of registration mark (Semi-automatic mode)
1. Place the sheet on the device and turn the sheet
set lever toward you.
2. Press or key to perform the sheet detection.
3. Move the cutter blade tip with the Jog key until it
rests in the area illustrated on the left.
4. Press key.
Registration mark detection starts.
5. After detected the registration mark, length (A)
provided between TP1 and TP2 will be shown
on the LCD. Press key.
The size is calibrated automatically in FineCut
mode. No need to input the actual size with the
jog key.
6. After detected the registration marks, length (B)
provided between TP1 and TP3 will be shown
on the LCD. Press key.
7. The origin is set.