MIMAKI fine Cut 3 - Page 22

20
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
2 Click [Extract Contour] button.
Set the distance from the object to the contour.
Enter a negative value to perform off-cut.
3 Click OK . Extract the contour to create a path on FC
Contour Layer.
Troubleshooting : A part of contour protrudes (See page 41)