- 5.13 -
5. Press the [ENTER] key.
6. Repeat Steps 4 and 5 to correct the dot posi-
tions on Patterns 2 to 7.
Select the correct dot positions on each of the patterns.
Enter the dot position correction value on Patterns 1 to 7 and
then terminate dot position correction.
7. Press the [END] key twice.
The menu returns to the LOCAL mode.
MAINTENANCE
PATTERN 2 = 0. 0
MAINTENANCE
PATTERN 3 = 0. 0
MAINTENANCE
PATTERN 4 = 0. 0
MAINTENANCE
PATTERN 5 = 0. 0
MAINTENANCE
PATTERN 6 = 0. 0
MAINTENANCE
PATTERN 7 = 0. 0
< LOCAL >
width : 1272 mm
TWICE
To Next Page
Loading...
