- 5.23 -
Drawing setup conditions [LIST]
This function outputs the current settings of the device.
They are useful in carrying out maintenance of the device.
1. SET UP : Indicates a value that is specified with the FUNCTION.
2. PRINTadjust : Indicates a correction value for dot position.
3. REPLACE COUNTER : Indicates the number of times the ink cartridges are replaced.
4. VERSION : Indicates the version of the firmware and memory capacity of the
device.
5. PARAMETER : Used for service persons for maintenance.
MAINTENANCE
LIST <ent>
∗ REMOTE ∗
∗ ∗ LIST ∗ ∗
STEPS:
1. Select the [LIST].
page 5.2.
2. Press the [ENTER] key.
Plotting starts automatically.
3. Press the [END] key twice.
The menu returns to the LOCAL mode.
MAINTENANCE
LIST <ent>
< LOCAL >
width : 1272 mm
TWICE
To Next Page
Loading...
