- 3.3 -
Cleaning the platen
• Clean the platen after the platen cools down.
The platen may be stained by lint or dust since the media is cut on it.
Wipe out dirt using the supplied paper towel.
If it is stained by ink, drop the cleaning fluid using a dropper and then wipe out dirt using a
paper towel.
Cleaning the media sensor
Using the swabs, wipe out dust or dirt on the surface of the sensor.
Maintenance for frame components
If the frame components of the device have stained, dampen a piece of soft cloth with
water or neutral detergent diluted with water, squeeze it and wipe the frame components
clean.
To Next Page
Loading...
