MIMAKI JV3-75SPII - Troubleshooting Specific Problems; Media Jamming or Soiling; Heater Indicator Issues

- 6.3 -
Paper jamming arises/media is soiled
A jam of the media or a stained media is considered to occur when an unsuitable media is
used or the media is set improperly.
Are you using media specific
to the device?
Yes
Are you using media that has
neither curls nor bent ends?
Yes
Does the media hang over along
the platen?
Use media specific to the device.
Avoid media that has curls or
bent ends.
Use a take-up device or re-load
the media on the device.
page 2.11, 2.18
No
No
No
The [HEAT] or [CONSTANT] indicator does not go on
Check the basic operation.
Is the power of the device ON?
Yes
Is the power of the heater ON?
Yes
Is the heater temperature setting
effective?
Turn on the power of the device.
page 2.3
Turn on the power of the heater.
Set the temperature of the
heater.
page 2.20
No
No
No