- 4.3 -
1. Select the LOCAL mode.
Ascertain first that the device does not perform printing under the REMOTE mode, then
press the [REMOTE] key to enter the LOCAL mode.
2. Select the FUNCTION mode.
Press the [FUNCTION] key, and the device will enter the FUNCTION mode.
The FUNCTION mode is divided into two: the setup function and maintenance function.
Select either function.
3. Select a type.
There are four types. The FUNCTION mode can be set for each type depending on the
media type used.
4. Select the Function.
Press the Jog keys [ ] or [ ] to select the function.
5. Enter the Function selected.
Press the [ENTER] key.
6. Select a parameter.
Press the Jog keys [ ] or [ ] to select a parameter.
7. Enter the specified value.
Press the [ENTER] key.
8. Restore the LOCAL mode.
Press the [END] key several time to restore the LOCAL mode.
To Next Page
Loading...
