MINATO 1866 - Data Format Reception; Data Format Output; List Output; Control Code Output

8·7·' Data format reception
o All data reception
o Reception in the range of 0 to 32 k·bytes
IS~II~~ ~[]~D~I START
o Reception in the range of 32 k to 64 k·bytes
ISEDRII~~~8~~~EJ
8·7·2 Data format output
Note 1: If no data sent using this instruction after the
Programmer waits for approx. 120 seconds, "E·17"
is displayed on the display address section, resulting
in time out. "?" is output to an external equipment,
and the Programmer waits for a command in the
same mode.
IsERil 1.1 ~
L!?J~~~~
EJ ; Send of data 0 through 7FFFH
B
D
0
0
B
B
;sendOfdata
A·ENT ~ 7 ~ F ~ F ~ A·ENT ~ START
o through 7FFH
D ~ G~IA.ENTI~0~0~0~IA.ENTI ~B
8·7·3 List output
; Transfer of data
10 through FFFH
Output in the same format as the REMOTE "L" instruction.
(Same
as the data format output in 8·7·2.)
8·7·4 Control code output
47