7-20 7 Service and Maitenance
5. Use one hand to pinch the porcelain socket and the other to pinch the lamp
assembly.
6. Place the new lamp assembly into the porcelain socket.
7. Place the lamp base part with gap to the hole of the light source. When the
lamp base reaches half of the depth, rotate it clockwise until the restraining
screw is fixed.
8. Screw the retaining screw on the lamp base.
9. After the lamp assembly is assembled and the socket is fixed, install the table
panel.
Figure 7-3 Light Assembly Structure
Gap
Lamp
Base
Tungsten-
halogen lamp
10. Place the Power back to ON.
11. Log on the test and maintenance software. Username: bs120, Password:
BS20@Mindray!
12. Wait 20 minutes until the light source is stable, and then enter the
Maintenance screen and click New Lamp. Follow the software instruction to
refresh the air blank AD value (Background value).
To Next Page
Loading...
