Mindray BS-120 - Run Operating Software

3 Installation 3-9
3.3.4 Run Operating Software
 Turn on Main Power and the Power.
 Turn on the printer.
 Make sure the liquid tubes are well connected and there is enough deionized water
in the deionized water tank and enough space in the waste tank.
 After logging on the Windows operating system, double-click the shortcut icon of the
operating software on the desktop or select the BS-120/BS-130/BS-180/BS-190
operating software program from [Start] to start up the
BS-120/BS-130/BS-180/BS-190 operating software.
 After start-up, the analyzer will automatically conduct the following procedures:
checking the operating system and the screen resolution, closing the screen saver,
checking the color configuration, initializing the database and examining the printer.
NOTE
The screen resolution must be 1024x768. The color
configuration must be at least 8 bits.
 If all checkings are passed, the following dialog box is displayed. Enter the
username and password, and then click OK. For service personnels, log in with the
maintenance username. Username: bs120, Password: Bs120@Mindray!.
NOTE
While entering the username and the password, pay attention to
the letter case. Capital letters and small letters are different.
The username and password are for service personnels. Do not
release them to customers. Users can only use Admin or other
usernames set by Admin users to log in.