3 Installation 3-13
Parameter Description
R1 Blank It refers to the allowed absorbance range of the R1 blank.
(R1 refers to the reagent of a single-reagent test or the first
reagent of a double-reagent test)
The first edit box is the low limit; the second one is the high
limit. Void means no check.
Mixed Rgt.
Blank
It refers to the allowed absorbance range of the mixture of the
double-reagent test.
The first edit box is the low limit, and the second one is the
high limit. Void means no check.
Linearity
Range
It refers to the range in which the test result is linear with the
response.
The first edit box is the low limit, and the second one is the
high limit. Void means no check.
Linearity Limit
It applies to the Kinetic method only. It ranges from 0 to 1.
Substrate
Limit
It refers to the maximum absorbance change relative to the
starting point (the first point when the last reactant is added and
the mixing is done).
It applies to the Kinetic and Fixed-time methods only. It
ranges from 0 to 50,000.
Factor For the test with a pre-set calculation factor, you can directly
run it without running the calibration first.
Void means the calculation factor is invalid.
Prozone
check
Select to check the prozone.
The following parameters are available only when it is
selected.
q1 Prozone test point q1.
It is available when the Prozone check is selected.
q2 Prozone test point q2.
It is available when the Prozone check is selected.
q3 Prozone test point q3.
It is available when the Prozone check is selected.
q4 Prozone test point q4.
It is available when the Prozone check is selected.
PC Prozone limit PC.
It is available when the Prozone check is selected.
Abs Lower limit of prozone absorbance.
It is available when the Prozone check is selected.
To Next Page
Loading...
