13-34 Probes and Biopsy
Select the Needle
Select the proper needle according to the specification above, and adjust the needle shift to the
same specification of the selected needle.
CAUTION:
Ensure that all guide parts are properly fixed prior to performing a
biopsy.
13.2.4 Biopsy Menu/Guideline Verification
Adjusting the needle mark is necessary before each biopsy procedure.
1. Confirm that the needle-guided bracket has been installed securely in the correct position.
2. Prepare a container filled with sterile water.
3. Place the head of the probe in the sterile water and place a biopsy needle in the needle guide.
4. When the biopsy needle appears on the image, confirm that the biopsy needle is displayed at
almost the same position as the selected needle mark.
WARNING:
Prior to each biopsy procedure, be sure to verify the guide
line.
If the needle is not consistent with the guide line, DO NOT
perform the biopsy procedure.
You can perform guide line verification on a single live B/C image, and all biopsy-
irrelevant operations are forbidden.
Biopsy Guideline
Press <F11 Biopsy> to enter Biopsy or touch [Biopsy] on the touch screen.
You can also operate on the menu. Use touch screen operations as an example.
Select the biopsy bracket angle/guide line
If the needle-guided bracket supports more than one biopsy angle or guide line, select the
angle/guideline by touching the [Biopsy Kit: NGB-XXX-XX] on the touch screen (last two letters
are angle or the guide line).
Select the guide line dot size
Touch [Dot Size] to select the dot size from Small, Medium and Big.
Tip:
To Next Page
Loading...
Need help?
General
