System Maintenance 17-1
17 System Maintenance
Routine system maintenance shall be carried out by the user. System maintenance after the
warranty has expired is the full responsibility of the owner/operator.
The responsibility for maintenance and management of the product after delivery resides with the
customer who has purchased the product.
If you have any questions, please contact the Mindray Customer Service Department or a sales
representative.
WARNING:
1. Only an authorized Mindray service engineer can perform
maintenance which is not specified in this operator’s manual.
2.
For the sake of system performance and safety, perform
periodical checks of the system.
17.1 Daily Maintenance
You are responsible for daily maintenance.
17.1.1 Cleaning the System
WARNING:
1. Before cleaning the system, be sure to turn off the power and
disconnect the power cord from the outlet. Cleaning the system
while the power is “On” may result in electric shock.
2. DO NOT directly spray solution onto the monitor, system control
panel or hard surfaces that are under pressure or pumped.
Ingress fluid leakage into the monitor or system can damage the
monitor or system, causing possible electric shock or system
failure.
CAUTION:
Do not spill water or other liquids into the system while cleaning. This may
result in malfunction or electric shock.
NOTE:
1. DO NOT use hydrocarbon glass cleaner or cleaner for OA (Office Automation)
equipment to clean the monitor. These substances may cause deterioration of the
monitor.
2. Clean the control panel periodically, otherwise the button may become blocked with
dirt and the system will buzz while the button has no effect.
To Next Page
Loading...
Need help?
General
