Mindray DP-50 Vet - Application; Key Config

Setup 11-5
11.1.4 Application
Open the Application page via [Setup]-> [System Preset]-> [Application]. Through the page,
you can set the measure ruler, follicle and relevant information. For details, please refer to
the Operator’s Manual [Advanced Volume]
11.1.5 Key Config
Open the page via [Setup]-> [System Preset]-> [Key Config], as shown in the figure below.
 Key function setting
You can set the functions for <Print>, <Save1>, <Save2>, F-key (F1) and footswitch.
To assign a function to a key:
(1) Click to select the desired key in the Key Function column at the left side of the
page.
(2) Click to select a function in Function area. You can see the functions selected at the
right side of the select key.
(3) Click [Save] to complete function setting.
The following introduces an example as setting <Print> as “Send Image to USB disk”:
(1) Select “Print” in the “Key Function” list at the left side of the page.
(2) Select “Send Image to USB disk” in “Function” at the right side of the page.