Mindray DP-50 Vet - Biopsy Guide Procedures

12-14 Probes and Biopsy
Probe
Ambient
temperature
Relative humidity
Atmospheric
pressure
50L60EAV
-20℃～55℃
30%~95%RH（no
condensation）
700 hPa ~ 1060 hPa
75L50EAV
-20℃～55℃
30%~95%RH（no
condensation）
700 hPa ~ 1060 hPa
1. To prevent the probe from being damaged, DO NOT store it where it may be exposed to:
 Direct sunlight or X-rays
 Sudden changes in temperature
 Dust
 Excessive vibration
 Heat generators
2. When the probe is sent to the MINDRAY Customer Service Department or a sales
representative for repair, be sure to disinfect it and keep it in the carrying case to prevent
infection.
3. Sterilize the carrying case as necessary.
12.2 Biopsy Guide
WARNING:
1.
The person performing biopsy procedures must
understand diagnostic ultrasound thoroughly and
have been trained adequately, otherwise, side effects
may be caused in the animal.
2.
In situations listed below, the biopsy needle may fail
to penetrate the target. The incorrect biopsy may
cause various side effects in the animal.
 Use a needle-guided bracket that doesn't match
with the transducer.
 Mounts the needle-guided bracket incorrectly.
 Use a biopsy needle that is unsuitable for the
type of biopsy being performed.
 Use a biopsy needle that is unsuitable for the
type of biopsy being performed.
3.
Before and after a biopsy procedure is performed,
confirm that the needle-guided bracket is normal.
Manually confirm that the parts of the needle-guided
bracket do not slip off or move from their proper
positions. If the needle-guided bracket is used when
parts are not securely and correctly installed, the
animal may be injured. If an abnormality is found on
the needle-guided bracket, immediately stop using it
and contact MINDRAY Customer Service Department
or sales representative.