Mindray DP-50 Vet - Dual Probe Switching

4-8 Exam Preparation
(2) Roll the trackball and press <Set> to select the exam mode, and use the direction
keys to turn pages of the exam modes.
 To save the image parameters for the current exam mode quickly:
Click [QSave] in the Probe & Exam page or click the user-defined key for QSave to save the
image parameters in the current image mode as presets. A dialogue box pops up to prompt
you the operation will cover the current image preset data.
 Exit:
Click [Exit] or press <Probe> to exit, press <B>, <Freeze> or <ESC> can also exit the
screen.
4.3.3 Dual Probe Switching
You can preset user-defined key to implement switching probes between single B and 2B
mode. The function is only available to the probes of the same exam mode.
 In single B mode: press the user-defined key to switch the current window between two
probes (with Cine Memory in [Image Preset] is set to “Split”)
 In Dual B mode: press the user-defined key to switch two windows between two probes.
Preset the user-defined key via [Setup] (by pressing <Setup>)-> [System Preset]-> [Key
Config].
1. Select the user-defined key in the Key Function page on the left (Print, Save1, Save2,
F1); or, select the key of footswitch.
2. Select “Dual Probe” in the page of Advanced Features on the right.
3. Click [Save] to confirm the setting and exit the dialog box.
4. After returning the preset, the setting will take effect.