Image Optimization 5-25
5.9.1.1 Free Xros M Image Parameters
Parameters consistent with those in M mode are not to be introduced, please refer to
relevant section of the M mode, while special items of the Free Xros M mode will be
introduced in the following.
Display/Hide the M-mark Line
There are 1 M-mark line available.
Press the current green M-mark line.
The one M-mark line on the screen cannot be hidden.
Switching between the M-mark Lines
To switch between the M-mark status in Free Xros M mode.
Press <Set> to hide or show between the M-mark lines and press <Cursor> to
show the cursor.
The activated M-mark line will be green.
Adjustment of the M-mark Line
To adjust the position and angle of the M-mark line.
Position Adjustment
When the M-mark line is activated, move the trackball left and right to adjust
the position. The direction is recognized by the arrow at the end of the line.
Angle Adjustment
When the M-mark line is activated, move the trackball to adjust the fulcrum of
the line, and adjust through the [Angle] item on the menu.
The adjusting angle range is 0-360, in increments of 1.
5.9.1.2 Exit Free Xros M
In Free Xros M mode, click [Free Xros M] or press <B> or the user-defined Free Xros M key
to exit Free Xros M mode.
To Next Page
Loading...