A - 10 Operator’s Manual
A Barcode Reader
I 2 of 5 symbols setting
Select this option to decode only I 2 of 5 symbols containing a selected length. Select the length
using the numeric barcodes below. For example, to decode only I 2 of 5 symbols with 8 characters,
scan I 2 of 5 - One Discrete Length, then scan 0 followed by 8.
A.2.4 Scanning in Hand-Held Mode
Perform the following procedure:
1. Ensure all connections are secure (see the appropriate host chapter.)
2. Aim the digital imager reader at the barcode.
To Next Page
Loading...
