Parameter Menus Operations
2 - 40 0070-10-0666-01 Trio™ Operating Instructions
CAUTION: Prolonged and continuous monitoring may increase the risk
of skin erosion and pressure necrosis at the site of the
sensor. Check the SpO2 sensor site frequently to ensure
proper positioning, alignment and skin integrity at least
every eight (8) hours; with the Adult and Pediatric re-usable
finger sensor, check every four (4) hours; for patients of
poor perfusion or with skin sensitive to light, check every 2
- 3 hours; more frequent examinations may be required for
different patients. Change the sensor site if signs of
circulatory compromise occur.
2.4.3.2.1 Nellcor
®
SpO
2
Setup Menu
FIGURE 2-34 Nellcor SpO
2
Setup Menu
Accessing the Nellcor SpO
2
Setup Menu
To access the NELLCOR SPO2 SETUP menu, select SpO2 from the SpO2 parameter tile
using the Navigator™ Knob. Once in the NELLCOR SPO2 SETUP menu, use the
Navigator Knob to adjust settings. To close the menu, select NORMAL SCREEN (from the
menu or the Front Panel Keypad).
Nellcor SpO
2
Setup Menu Selections
ALM PRIORITY Enables the user to select the priority of the SpO
2
alarm. Choices are:
1, 2 and 3. Priority 1 alarms are considered the most serious.
ALM PRINT Enables or disables automatic printing during an SpO
2
alarm
condition. Choose ON to enable printing upon SpO
2
alarm. Choose
OFF to disable printing upon SpO
2
alarm.
SPO2 ALM HI Allows the user to set the upper limit of the SpO
2
alarm.
(See “Nellcor SpO2 Alarm Limits” on page 2-42.)
SPO2 ALM LO Allows the user to set the lower limit of the SpO
2
alarm.
(See “Nellcor SpO2 Alarm Limits” on page 2-42.)
To Next Page
Loading...
Need help?
General
