4-11
NOTE
z Anesthetic agent bottle must not be stored with filling adapter connected, otherwise
anesthetic agent will escape.
z During disconnection of the male adaptor from the vaporizer and the bottle adaptor
from the bottle, small amounts of anesthetic agent will escape to the environment.
4.2.3 Quik-Fil System
If the vaporizer is connected to the anesthetic delivery system, fresh gas flow can remain as set.
1. Turn the control dial clockwise back to “0” position until the “0” button pops up.
CAUTION
z It is necessary to wait at least 5 seconds after setting the control dial to the 0 position
before opening the vaporizer. This allows the pressure to balance and prevents fresh
gas and anesthetic agent vapor froming escaping from the vaporizer.
2. Select the correct filling adapter and anesthetic agent bottle. Remove cap from the anesthetic
agent bottle, checking that the bottle and filler mechanism are not damaged. Screw the
Quik-Fil adapter firmly into the anesthetic agent bottle.
3. Remove the cap from the anesthetic agent bottle, checking that the bottle and filler
mechanism are not damaged.
4. Screw the Quik-Fil adapter firmly into the anesthetic agent bottle.
WARNING
z Significant quantities of anesthetic agent vapor may escape if the control dial does not
return to “0” position.
CAUTION
z If the connection between the filling adapter and anesthetic agent bottle is not
leak-tight, anesthetic agent may escape.
z Agent-specific filling cannot be assured when bottles without collars used.
To Next Page
Loading...
Need help?
General
