Figure 7-2: Setup; General; Auto Launch Total Recall Imaging
•
Selectively Load Total Recall Data: No Setup is necessary.
• Total Recall data will NOT automatically be loaded when an image or clip is
selected for Review
• An OLED will become available with options to ‘Load TRI’ or ‘Delete TRI’ data if
an image with TRI data is selected for Review.
• Once ‘Load TRI’ has been selected, OLED options will change to ‘Exit TRI’ or
‘Delete TRI’.
When an image or clip is selected and TRI Data is loaded (during Review or from Archive),
Total Recall becomes the Priority state of the system with the following OLED controls
available:
Total Recall
Control
Description/Use
Exit Review
Return to live imaging.
Trim Define the start and end point of a clip to re-save.
Tag Mark an image or clip to allow exporting or sending selective images.
Format Toggle between multi image and full image with thumbnails format of Review.
To Next Page
Loading...
