10 Assembly
Continued...
Note: If the Quick-Trak cable
becomes loose try securing
it onto the shaft with
electrical tape.
Attaching the Armrest Straps to
the Armrest:
1 Press both strap studs onto the armrest studs.
2 Push the armrest straps through the slots in the armrest
cover and then slide the cover over the armrest.
Connecting the Control Box to
the Upper Shaft:
1 Place the detector on a flat surface, with the handle
facing upwards.
2 Position the armrest on top of the control box.
3 Clip the control box onto the armrest, ensuring the battery
plug faces away from the coil.
4 Fasten with the wing-nuts.
5 Wind the Quick-Trak button cable around the upper shaft
and plug it into the Smart Point socket in the control box.
Ensure that the cable is wrapped firmly but avoid strain on
the connector.
To Next Page
Loading...
