11
Connecting the Coil Cable:
1 Wind the coil cable around the lower and upper shafts
enough times to take up the slack. Leave enough slack at
the bottom of the cable near the coil to allow the angle of
the coil to be adjusted while detecting.
2 Use the velcro straps to secure the coil cable to the shaft.
3 Plug the coil connector into the coil socket on the control
box, firmly tightening the retaining ring to hold it in place.
Always ensure that the control box is turned off before
connecting or disconnecting the coil to avoid damage to
the detector's electronics.
To Next Page
Loading...
