FrameMaker Ver.5.5E(PC) DIS/REASSEMBLY, ADJUSTMENT FOR Di152/Di183
01.09.03
D-40
<Left Fusing Roller>
13. Snap off one retaining ring.
14. Unhook the spring in the rear of the Guide Assy.
15. Unhook the spring at the front of the Guide Assy.
16. Remove the Guide Assy.
NOTE
• When removing and reinstalling the Guide Assy,
use care not to allow the sensor lever spring to be
unhooked.
17. Remove one screw and the Paper Separator Fin-
ger Assy.
NOTE
• When reinstalling the Paper Separator Finger
Assy, allow six tabs to be caught in the frame.
18. Remove two screws and the mounting bracket.
19. Remove the idle gear.
To Next Page
Loading...
