32
AUTO-RECORDING MODE
The drive modes control the rate and method images are captured.
Icons indicating the selected drive mode appear on the data panel and
LCD monitor.
To change the drive mode, simply press the drive-mode button (1) on
the back of the camera until the desired mode is displayed.
DRIVE MODES
Single-frame
advance
Continuous
advance
Self-timer/ Remote
control
Bracketing
To take a single image each time the shutter-release
button is pressed (p. 23).
To take multiple images when the shutter-release but-
ton is pressed and held.
To delay the release of the shutter. Used for self-por-
traits.
To take a series of three images with
differing exposures.
LCD monitor
Data panel
All icons have been shown
for clarity. The single-frame
advance and continuous
drive indicators occupy the
same area of the data panel.
All the drive-mode icons
appear in the lower right
corner of the monitor.
LCD
Monitor
Data
Panel
1
To Next Page
Loading...
Need help?
General
