99
CONNECTING TO MAC OS 8.6
To download and install this software, follow the instruction on the Apple web site. Always read the
attached terms and conditions before installing any new software.
To access this camera with a computer with Mac OS 8.6, the USB storage support 1.3.5.smi must be
installed first. This software is supplied by Apple Computer, Inc. free of charge. It can be downloaded
from the Apple Software Updates web site at http://www.apple.com/support.
AUTO POWER SAVE (DATA-TRANSFER MODE)
If the camera does not receive a read or write command within ten minutes, it will shut down to save
power. When the camera shuts down, an unsafe-removal-of-device warning may appear on the com-
puter monitor. Click “OK.” Neither the camera or computer will be damaged in this operation.
Turn off the camera with the mode dial. Remake the USB connection by turning the mode dial back
to the data-transfer position.
To Next Page
Loading...
Need help?
General
