Action
Using the Corona Unit Cleaning Levers, clean the Corona Units.
➭
p. 176
Wipe the Original Glass clean of dirt with a soft dry cloth.
➭
p. 174
Wipe clean the Original Pad or Document Feed Belt with a soft cloth dampened with
neutral detergent.
➭
p. 174
Place a blank sheet of paper over the original for making copies.
➭
p. 38
The information on the back side of a two-sided, thin original can be slightly reproduced
on the copy. Set the copier into the Manual Exposure Mode and, using the Exposure
Control Key (Lighter), make the exposure level lighter.
➭
p. 47
Wipe clean the Original Pad or Document Feed Belt with a soft cloth dampened with
neutral detergent.
➭
p. 177
Select the paper size that is the same as the original.
➭
p. 38
Or, use the Auto Size Mode to make an appropriately enlarged copy.
➭
p. 174
Select the paper that is loaded in the same direction as the original.
➭
p. 54
Or, reload the paper in the same direction as the original.
➭
p. 51
Select the zoom ratio according to the copy paper size.
➭
p. 54
Or, use the Auto Size Mode to make an appropriately reduced copy.
➭
p. 51
Place the original correctly on the Original Glass against the Original Width Scale.
➭
p. 38
Or, load it onto the AF-3/AFR-7 correctly along the Document Guide Plates.
➭
p. 41
Raise the AF-3/AFR-7 and place the originals on the Original Glass, one at a time,
instead of using the AF-3/AFR-7.
➭
p. 43
Wipe the Original Glass clean of dirt with a soft dry cloth.
➭
p. 174
If these procedures do not correct the problem, contact your Tech. Rep.
1. When this Type of Copy is Produced
Chapter 6
Troubleshooting
155
To Next Page
Loading...
